TF010 Light load rear coil springs are designed to provide 2” of lift on a standard 110 Defender with no additional equipment fitted, they will carry light to moderate loads but may not maintain a 2” lift.

These springs could be fitted to a 130 but only if no lift was required.

They can be fitted in conjunction with TF014 to give a comfortable ride and a 2” lift to an unladen 110.  

Spring Selection

It is important to understand that all Terrafirma Coil Springs have been designed to provide approximately 2”  (50mm) of lift while carrying light, medium or heavy loads. Minimal mechanical changes are required when lifting by this amount, however the Terrafirma Hardware range of accessories does allow for greater lift and significantly increased wheel travel, further enhancing off-road ability.

Selecting the most suitable springs for a Land Rover may be with some compromise. A heavy load spring needed when fully loaded may ride too high and too hard when unloaded. Likewise a light load spring that is comfortable and flexible will not achieve the desired lift or carry the heavy loads associated with expedition vehicles.

Load carrying coil springs are often progressive or variable (V) this provides a combination of comfort and load carrying in one spring.

It is worth noting that Terrafirma coil springs are sold in pairs, in many cases one spring is 10mm longer than the  other, the longer spring should always be fitted to the driver’s side.